Fronius Acctiva Professional 42 - Manual (Page 21)

V
ud_fr_ls_sv_01055 012011
EN
Chargers with the EC marking satisfy the fundamental requirements of the
low-voltage and electromagnetic compatibility directive. Safety
The warranty period for the charger is 2 years from the date of invoice.
However, the manufacturer will not accept any liability if the damage was
caused by one or more of the following:
-
Use of the charger „not in accordance with the intended purpose“
- Improper installation and operation
- Operating the charger with faulty protection devices
- Non-compliance with the operating instructions
- Unauthorised modifications to the charger
- Catastrophes caused by the activities of third parties and force majeure
Guarantee and
liability
Devices with the TÜV test mark satisfy the requirements of the relevant
standards in Canada and USA.
Devices with the TÜV test mark satisfy the requirements of the relevant
standards in Japan.
Do not dispose of this device with normal domestic waste!
To comply with the European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment and its implementation as national law, electrical
equipment that has reached the end of its life must be collected separately
and returned to an approved recycling facility Any device that you no longer
require must be returned to our agent, or find out about the approved
collection and recycling facilities in your area.
Ignoring this European Directive may have potentially adverse affects on the
environment and your health! Disposal
The operator is obliged to arrange a safety inspection of the device at least
once every 12 months.
The manufacturer recommends that the power source is calibrated during
the same 12 month period.
A safety inspection must be carried out by a qualified electrician
- after any changes are made
- after any additional parts are installed and after any conversions
- after repair, care and maintenance
- at least every twelve months.
For safety inspections, follow the appropriate national and international
standards and directives.
Further information on safety inspections and calibration is available from
your service centre, who will be happy to provide you with the required
documentation.
Safety inspection