Enviroflex, Filter – ENVIROMAC MAC1 107.1020 User Manual
Page 8

ENVIROFLEX
FOR A HEALTHIER WORK ENVIRONMENT
IN U.S.A.
ENVIROFLEX INTERNATIONAL INC.
1051 CLINTON ST.
BUFFALO NY, USA 14206-2823
TEL. (716) 883-2319 FAX (716) 892-2139
TOLL FREE 1-866-ENV-FLEX
Internet: http://www.enviroflex.com
Email: [email protected]
IN CANADA
ENVIROFLEX INTERNATIONAL INC.
17 BROWNRIDGE RD. UNIT 8
HALTON HILLS, ONTARIO, CANADA, L7G 0C6
TEL. (905) 636-1177 FAX (905) 636-1178
TOLL FREE 1-877-ENV-FLEX
Internet: http://www.enviroflex.com
Email: [email protected]
Precoat Instructions for ENVIROMAC
Precoat Instructions for ENVIROMAC
Precoat Instructions for ENVIROMAC
Precoat Instructions for ENVIROMAC
Filter
Filter
Filter
Filter
Prior To Initial Use
The cartridge filter has to be pre-coated with 2 cups of Precoat prior to initial use. The
precoat should be fed into the pickup hood at the end of the Snorkvac™ Arm. After pre-
coating the filter let the fan operate for two (2) minutes to allow the Precoat to settle on the
inside of the filter.
After Initial Precoat
The suction will deteriorate as the filter loads up with particulate. When it is time to clean the
filter you remove the filter, turn it upside down, blow it out on the outside with compressed
air then insert back into the machine and precoat the unit the same as the initial precoat
instructions.
The filter can be cleaned with water as the media does not retain any moisture. However,
getting rid of the water and particulate could be a problem as people are concerned with
dumping hazardous particulate down a drain.
You can dispose of the particulate in a bag if the filter was cleaned with compressed air.
Date: November 14, 2008
Section 2B