April Music Aura note V2 Upgrade - Manual (Page 2)

Windows Sound Setup
1
1. Aura note V2 Firmware Upgrade procedure
1) Download latest Firmware file at following destination.
[ www.aprilmusic.com Home > Support > Manuals > Aura note V2 Firmware file & Upgrade
procedure]
2) Copy downloaded Firmware file to empty USB memory.
※ There should be no other file except downloaded Firmware file in the USB memory. If there is
any old Firmware file in the USB memory, please delete it and copy downloaded latest Firmware
file. (recommand format the USB memory before copy Firmware file)
3) Select “USB” mode of Aura note V2.
4) Connect USB memory to USB Type A connector on the right side of Aura note V2.
Then automatically progress Firmware Upgrade. (Time for Firmware Upgrade is about 1 min)
"UPGRADE"......."SUCCESS"....“Automatically reset and “tick” sound”....”SUCCESS”
※ Do not press any button on the front panel or remote control during Firmware Upgrade. It may
cause critical error.
5) Disconnect USB memory and power off Aura note V2 by using the power switch on the rear
panel.
6) Power on Aura note V2 after few seconds. Then Firmware Upgrade is done.
2. FM frequency bandwidth setting for each country
When the Firmware Upgrade is done, you should set the tuner frequency for your region.
1) Press the “STOP” button on the front panel for 5 seconds, then release the “STOP” button and
press the “ENTER” button on the remote control. "OPT USA" will be displayed on the front panel
display.
2) Use I< & >I keys on the remote control to choose appropriate FM mode for your country.