Aervoe 200-Watt Converter - Manual

Max Burton ® 200 Watt Converter #6993
IMPORTANT SAFEGUARDS
Read all instructions before operating •
Do not immerse cord or plug in water or other liquids •
Do not let cord hang over edge of table or counter •
Do not use for anything other than its intended use •
Unplug when not in use •
Never use if the 120V AC or 12V DC cord or plug is damaged •
This unit will not shut off automatically. Turn off immediately after •
use.
Administer close supervision when using around children •
CAUTION: Risk of Electric Shock.
Dry location use only
PARTS IDENTIFICATION
OPERATION
The 200 Watt Converter allows you to use any Max Burton 12-volt
appliance with 120-volt power. You may use other 12-volt appliances
and accessories with this converter up to 200 watts/15 amps.
Insert a 12-volt plug from any DC 12-volt appliance, accessory, or 1.
tool into the DC OUTlET end of the converter.
Insert the 120-volt AC plug into a 110-120V AC electrical wall 2.
outlet.
Turn on POWER SWITCH and the red lED indicator light will 3.
illuminate showing that power is being provided adequately.
The cooling fan will operate at all times. Do not use if fan does not 4.
operate properly.
MOUNTING
The converter may be mounted to any flat, stable surface using the
mounting brackets included on the bottom of the converter.
TROUBLESHOOTING
If the 12-volt appliance fails to operate, try the following suggestions:
Unplug from the power supply an make sure that the receptacle is 1.
clean. DO NOT USE METAl TOOlS. If cleaning is needed, use
only insulators, such as wood.
Check the fuse in the 12V DC appliance. Carefully unscrew the 2.
plug’s top section. Remove and check the fuse with the proper
electronic meter. If defective, replace with correct fuse (see
specification for type). Also check the vehicle’s fuse panel.
Consult the operating instructions for your 12V appliance for 3.
additional and troubleshooting information.
120V Plug
LED Indicator Light
Cooling Fan
Power Switch
12V Socket
Mounting Brackets
(not visible)