Adept AdeptSight User Guide User Manual
Page 106
AdeptSight Camera Calibration Wizard - Automated, with Belt
Locating Calibration Target
1. Place the target near the upstream limit, within the work area.
2. Adjust the bounding box to the work area. This must include the calibration tar-
get.
3. If the target isn't marked with a magenta origin, click Run.
If necessary, move the target so it can be located, then click Run.
Related Topics
AdeptSight Belt Calibration Interview Wizard on page 59
AdeptSight Belt Calibration Wizard on page 65
AdeptSight Camera Calibration Interview Wizard on page 75
AdeptSight Camera Calibration Wizard - Automated, no Belt on page 85
AdeptSight Camera Calibration Wizard - Automated, Arm-Mount on page 109
AdeptSight Camera Calibration Wizard - Automated Upward-Looking on page 121
AdeptSight User's Guide, Version 3.2.x, Updated: 8/23/2012
Page 106