Tempest Thunder - Manual (Page 10)

Thunder Enclosure User Manual page 10
Blizzard XYZ Mount
All Blizzard and Thunder enclosures may be mounted using the adjustable Blizzard XYZ mount (part
# 6500.XYZ). The XYZ Mount is designed to mount on the bottom of a piece of 1½” schedule 40
pipe (48-50mm Outside Dimension).
Part #: 6500.XYZ
Adjustment Range:
Vertical: +60° to -90°
Horizontal: 360°
Roll: ± 10°
Continued/…
Spring nuts lock into
Unistrut rails on
Blizzard base
IMPORTANT
Drill a 3/8”/10mm hole through the bottom of your
vertical pole, and use this bolt and locknut to fix
the safety collar in place
Tighten this knob both
sides to lock tilt
movement
This bolt should be
just tight enough so
the projector can tilt
with a little hand
pressure.
Friction Pad ensures a
tight grip when locked
down
Tighten this knob to
lock horizontal (pan)
movement
Tighten these screws to raise this side
(roll), or loosen to lower it.
Then…
Tighten the locknuts up under the yoke to
lock the roll position.
The Safety Collar
MUST be bolted
through the bottom of
the pole, below the
yoke
YOKE
CRADLE
SAFETY
COLLAR