beautypg.com

Ergotech One-Touch FlexView User Manual

Page 5

background image

closest  to  the  back  of  the  unit  as  shown  in  the  picture.    The  hole  in  the  center  of  the  bracket  will  not  be  
used.    

 

 

 

 

 

 

Set   the   lift   assembly   to   the   side.     Mark  
where  the  fasteners  will  be  placed.  Mark  
out  positions  of  two  holes  on  the  wall  47”  
From   the   ground   and   9-­‐3/8”   Apart.   If  
using   Hilti   toggle   fasteners,   refer   to  
instructions   on   package.   Install   the   top  
two   fasteners   so   they   are   sticking   about  
approximately  1  inch  from  the  wall.  

 

 

 

Hang   the   unit   on   the   top   two   hooks   and   be   sure   the   unit   is  
fully   against   the   wall.   Mark   the   position   of   the   bottom   two  
hooks,   remove   the   unit   from   the   wall   and   set   to   the   side.  
Repeat  process  for  installing  bottom  two  bolts,  again  leaving  
them  sticking  out  from  the  wall  approximately  1  inch.