Dynaudio BX30 User Manual
Page 8
BX30 Owner’s Manual
8
Figure 4. Output control and connectors
CROSSOVER
High Pass: Changes round the OUT line signals between :
Direct: The signal on XLR IN connectors is directed to the XLR OUT.
95 Hz: The signal on XLR IN runs through a 95 Hz high pass filter, before it is
send to the XLR OUT.
IN
L and R : Balanced line signal input.
Pin 1 : Ground
Pin 2 : Non inverted (hot)
Pin 3 : Inverted (cold)
OUT
L and R: Balanced line signal output.
Pin 1 : Ground
Pin 2 : Non inverted (hot)
Pin 3 : Inverted (cold)
If CROSSOVER High Pass is set on 95 Hz and the BX30 is turned off, the relays
in the amplifier will change and thereby the OUT signal will disappear.