American Weigh Scales (AWS) CP2-50 User Manual
Page 4
4. The display will show “Zero” followed by the
required calibration weight (see chart above). Place
the required weight on the platform then press the
[ ] key again.
5. The display will show “F” for finished.
6. Remove the weight and press [ ] to turn the scale
off. Calibration is complete!
V. TROUBLESHOOTING
The primary reasons for inaccuracy or malfunction
are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in
mind and maintain and operate your scale properly.
This scale is a precise instrument and must be
handled with the utmost care and caution.
[Display] Elimination of errors
-----------------------------------------------
[Lo]
Change the batteries.
[OUT2] Recalibrate the scale as shown above.
[O_Ld] You are overloading the scale. Remove the
excessive load immediately!
[UnST] Use the scale in a more stable position