Alto Professional Stealth Wireless Expander Pack - Manual (Page 6)

6
Connection Diagrams
Single Channel Setup
To send mono signals through the Stealth Wireless transmitter to a single receiver:
1. Connect your mixer’s main output to an input on the Stealth Wireless transmitter, and connect the
receiver’s output to your loudspeaker’s input. Keep all mixer volume and transmitter Trim controls
their minimum settings.
2. Power on the Stealth Wireless transmitter and receiver. Set their channels to matching numbers.
3. Adjust the transmitter and receiver antennas to a vertical position.
4. Set the transmitter to “mono” and adjust the Trim control to get a strong signal without clipping.
5. Turn on your loudspeaker, adjust the output level on your mixer, and adjust the Trim controls on
the transmitter to hear the audio signal. If
you hear noise in the signal , change to a different
channel until a clean signal comes through.
Receiver
Powered
Speaker
Mixer
This diagram shows
the signal flow from a
mixer, through Stealth
Wireless, to a speaker.
Transmitter