ABtUS AB2123108 - Manual (Page 2)

Instructions for use AB2123108
User Operation Guide
Congratulations on the purchase of your ABtUS Projection Screen Paint. Soon you
will be enjoying the benefits of the perfect projection screen for your specific situation.
It is important that you carefully follow each step of the instructions on the following
pages. You also need to have a little bit of patience for the next few hours. Because
of the drying time that is required for the different layers of paint, you might easily
need eight hours to apply the product. (Of course, you can do the first steps today
and continue later.)
This package contains:
1 litre BaseCoat (Light Grey), 1 litre TopCoat (Brightness / Gain 1.1).
Special Note:
A synthetic surface cannot absorb any liquid. While drying, temporary air bubbles may appear in the paint
that has been applied. Do not touch them. They will disappear by themselves as the paint dries.
- Absorbency:
If the wall is very absorbent, you should first treat it with a pre-paint coating. (The amount that
you need will be determined by the type of surface)
- Dirt:
If the wall is very dirty (for example, smoke stains, water stains) you will first have to treat it
with a good stain-blocking paint.
- Dark:
If the surface is very dark you will first have to treat it with a standard white wall paint.
MAKE YOUR OWN SCREEN IN 4 EASY STEPS:
Before you begin Page
- The surroundings and temperature 3
- The surface upon which ABtUS will be applied 3
Step 1: Determining the location, size and dimensions of the screen 4
Step 2: Applying the basic layer of paint (BaseCoat) 5~6
Step 3: Applying the top layer of paint (TopCoat) 6~7
- 3.1 Applying the top layer
- 3.2 Wait for screen to harden
Step 4: The enormous fun can begin 8
Final notes
- Maintenance 8
- Safety
- Guarantee
BEFORE YOU BEGIN
Shake all products well for at least 15 seconds
Tips
Inspect the wall closely and repair
any small irregularities, scratches
or holes. Then sand the wall lightly
to even it out.
- Walls with a synthetic finish:
If your wall or surface has a very smooth synthetic finish, you must first apply an adhesive layer
so that the ABtUS paint system can adequately adhere to the wall. Walls made of particle board
or MDF should be thoroughly cleaned with turpentine or paint thinner. You must also apply an
adhesive layer to these walls.
The surroundings:
Make sure that the area and surface that will be painted are free of dust and that no air circulation
system is on (for example: air conditioning, fan). This ensures that no dust will stick to the wet
wall while the paint is being applied.
The temperature:
The ABtUS paint system can best be applied at a room temperature that is between 15 and 25º
Celsius (59 and 77º F) and with a humidity that is between 40 and 70 percent. A different room
temperature or humidity can require a longer drying and thereby waiting time. (Important: The
paint layers cannot be applied if the room temperature is lower than 5º Celsius (41º F).
The wall (or other surface) upon which the ABtUS paint system will be applied
The ABtUS paint system can be applied on stone, cement, wood, plastic or sheetrock and on all materials
that have already been painted with a normal wall paint. You do, however, have to check the following:
- Flat:
Important: The wall must be flat or flat enough (if you stand 2 or 3 meters (6 or 9 feet) from the
wall it should look flat and even). (See illustration)
**Specification are subjected to changes without notice...for detail and updated information please visit www.abtussinagpore.com 03 02