Z-Systems z-8.8 digital detangler - Manual (Page 3)

Z-Systems Audio Engineering z-8.8 Manual
To load a previously-saved configuration, first hit the load button. The z-8.8 in
load mode is shown in Figure 4. Simply rotate the left knob to bring up the
desired "patch" number and then hit the
load button again to finish the
operation. To abort the load operation, just hit the cancel button. Hitting either
load or cancel will return you to the normal mode of operation. Notice that
when you complete the load operation that the settings are not sent to the
connection matrix. You must hit the
route button to make the loaded preset
take effect. Note: When you hit the route button, the current configuration is
written to store location 00 automatically. When the z-8.8 is powered down and
then turned back on again, the configuration stored in location 00 is
automatically loaded and sent to the connection matrix.
Figure 3 -- Save preset mode