Star Headlight & Lantern 274-RCK - STAR-RACK - Manual (Page 3)

-3-
Component Installation
1. Remove the four screws
securing one of the endcaps on
the 274-RCK and slide the
endcap off.
If you have a traffic director
version, remove the endcap
from the end OPPOSITE the
cable.
When reinstalling, ensure the
gasket is seated properly so
that it will not leak.
Installation of most optional components will require temporary removal of the end caps to
slide bolts onto the extrusion and/or to run wiring inside the extrusions. Proceed as follows:
(shown with optional traffic director)
2. If you wish to route any wires from your components
around the bottom of the extrusion and inside of it,
it is recommended that you remove the front
extrusion to allow for easy access to the
inside of the rear extrusion.
A. Loosen any nuts that secure any mounting plates/brackets to the front extrusion.
B. Loosen the two nuts on each mounting bracket that secures the
mounting brackets to the front extrusion.
C. Remove the four screws securing
both endcaps to the extrusion and
slide the endcaps off.
D. Slide the front extrusion off the bolts attaching
the mounting legs and strobe light plate.
3. If necessary, slide the plastic “window” out of the rear
extrusion exposing the inside of the rear extrusion. (Your
rack may come with the window separate.)