Physitemp Instruments EB HL1 - Manual

W P:\CW shared\Operating Manuals\EB HL-1
PHYSITEMP INSTRUMENTS INC
154 Huron Avenue
Clifton NJ 07013 U.S.A.
Tel: 973-779-5577, Fax: 973-779-5954
e-mail: [email protected]
HL-1 HEAT LAMP
INSTRUCTIONS FOR USE
Screw bulb into lamp socket
Install guard. Place 3 of the wire arms inside the rim of the shade then
press fourth arm into position on rim. (Note: for safety and comfort, guard
must be attached whenever lamp is used).
To Use
Position lamp at a distance 10 to 14 inches above the object. Adjust swing
arm and shade to direct heat precisely where you want it. Exposure for
short intervals (15 to 20 minutes) usually provides the best results.
Use of a heat lamp for medical purposes should be prescribed by a
physician before treatment.
To Remove and Replace Bulb
Unplug power cord. Press any arm of guard inward and pull down to
remove guard from shade. Unscrew and replace bulb – use 250W heat
lamp only. Replace guard.
Caution: Temperatures sufficiently high to cause burns occur. Do
not use on an infant, invalid or sleeping or unconscious person. Do
not use on persons with insensitive skin or poor blood circulation.