Denon AVR-687 - Manual (Page 13)

Easy Setup Procedure Easy Setup Procedure
ENGLISH
10
ENGLISH
Auto Setup
The AVR-687’s auto setup use the attached microphone to measure
the acoustic properties in the room and automatically make the optimum
settings.
• To make the sound field settings manually ( page 45 ~ 47).
q Connecting a microphone
Connect the attached setup microphone to
MIC> .
Mount the setup microphone on a camera tripod, etc.,
and set with the receptor pointing towards the ceiling.
Microphone
Place the setup microphone’s sound receptor at the height of the
ears in the listening position.
It is not possible to measure properly if there are any obstacles
between the speakers and microphone. Check that there are no
obstacles.
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
Sound receptor
1
2
Press or [ON/SOURCE] .
• The power indicator blinks green and the power turns on.
Press .
£ OFF:
The power turns off and the indicator is off.
¢ ON:
The power indicator lights red.
Turn on your subwoofer.
Set the volume to halfway and set the crossover frequency to
the maximum or Low pass filter off if your subwoofer can adjust
the output volume and the crossover frequency.
Some subwoofers have a standby mode. Be sure to turn this
function off before performing the Auto Setup procedure.
Turn on your monitor.
w Before performing the Auto Setup procedure
1
2
3
4
Set [MODE SELECTOR 1] to “AUDIO”. 5
• Auto Setup mode is not displayed when using headphones.
e Switching the front speaker
Press to select the front speaker (Front A,
Front B or Front A+B).
[MODE SELECTOR 1]
[ON/SOURCE]
D H F G
D H F G
D H F G