LG Motorsports LG C6 Carbon ZR1 Splitter - Manual (Page 5)

Once the front bolts are in place you can now install the rear brace for the splitter. This is
the small black aluminum piece that is included. For this you will need a drill as well
(3/16”) to complete.
Hold the bottom of the splitter level with the ground and you will bolt this piece to the
splitter and to the top section of the rubber air damn under the car.
Figure 6: Mock up for install of brace:
Once you mock up your brace, mark the holes in the splitter first and drill these. You will
now bolt the support to the splitter once these three holes are drilled, using the supplied
hardware. There are already three holes in the aluminum support, use these as a template
to mark the holes for the splitter piece. When installing the bolts, place the small washer
between the bolt head and the aluminum and the large washer on the back side between
the splitter and the nut.