Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 10)

Labconco Glassware Washer Service/Technical Manual
4
20. Press the ▼ button and the arrow on the display will point to COOL FAN.
21. Press either the ► or ◄ button, and the small fan inside the kick panel
will operate.
22. This completes the check of most of the washer functions. Unlatch the
door to exit from the Diagnostics mode.
23. To verify the proper operation of the overfill switch, repeat steps 1 & 2
above. Press either ► or ◄ button and allow tap water to enter the tank
until the water flow turns off.
24. Press and hold the RUN button. Water will enter the washer and should
turn off before it overflows.
25. Press the ▼ arrow until DRAIN/COOL is highlighted.
26. Press ► or ◄ button to drain water from the washer.
27. Unlatch the door to exit from the Diagnostics mode.
Performing a Factory Reset
Like any computer and software, sometimes it is necessary to reset the PC
Board. If you experience a Lock-up on the display screen, or if your
programs aren’t being saved, follow the directions below to perform a FACTORY
RESET.
1. Open latch on door.
2. Close the latch on the door.
3. Press ▼ button as the Display reads “Labconco Glassware Washer: Version X”
4. Release ▼ button and display will show the “Set Up” screen.
5. Press ▼ until FACTORY RESET is highlighted.
6. Press ► or ◄ until “Yes” is displayed.
7. Press RUN.
Washer Layout and Landmarks
Before getting into the washer to perform service, it is important to know
where the major systems and their parts are. In the field, you will not have
the luxury of seeing where everything is, unimpeded. The pictures below
serve as a roadmap to systems in the base of the unit.
FlaskScrubber® SteamScrubber®
The pictures are shown in the same orientation, the front of the machines are
at the bottom of the photos.