American Energy Systems MagnuM T40 - Manual (Page 7)

7
When you receive your Avent Wood Pellet Stove be careful to inspect all parts and components to make
sure that nothing was damaged or lost in shipment. If there was shipping damage, be sure to report it to
your Avent Wood Pellet reseller, or the shipping company that delivered your unit. Freight damage
claims must be made to the Freight Company immediately. If parts are missing contact your local
Avent Wood Pellet reseller or contact the factory right away. Your satisfaction is our top priority.
To uncrate your Avent Wood Pellet Stove:
1) Cut the banding straps and open the carton lid. The carton is stapled to the wood pallet so it will be
necessary to pull the cardboard loose from the pallet. Remove the crating box carefully lifting up over
the top of the unit. Be careful not to scratch the unit with the staples. Remove the wood blocks and
plastic. We strongly urge you to recycle the packaging materials to help protect the environment.
The Avent Wood Pellet Freestanding Stove may be installed on a combustible floor, with proper floor
protection, or on a masonry hearth. The hearth or non-combustible floor protector must extend a
minimum of (6) six inches (152mm) in front of the unit and beyond each side of the fuel loading and ash
Removal openings.
The stove must be installed with the following minimum clearances to side and back wall combustible
materials. NOTE: These are minimum clearances to combustible walls established by the testing lab.
The amount of room needed on the left side of the unit to access the electrical panel is (6) six inches.
UNPACKING YOUR AVENT WOOD PELLET STOVE
FLOOR PROTECTION
CLEARANCES TO COMBUSTIBLES
A= Left
B= Right
C
E
D
D
A=4” B=4”
C=4” D=3”
E=8.5”
Residential/ Mobile Home
Vertical Installation
Residential/Mobile Home
Horizontal + Vertical
Corner Installation