Dash cutout – Dakota Digital CLK-1002B User Manual
Page 2
Wiring:
BLACK
-
connect to a good ground point in the vehicle.
RED
-
connect to switched 12 volt power point.
(An accessory terminal will work for this.)
ORANGE
-
connect to a constant 12 volt power point.
(This will keep the correct time.)
BLUE
-
connect to the tail light circuit.
Mounting:
The gauge requires an oval cut out that as shown below. It should be inserted into the opening from the
front and the U-clamp will be installed from the back. Tighten the two nuts on the U-clamp so that the gauge is
secure. Figure 2 shows the required cut out for the gauge. Figure 3 shows how the gauge mounts.
DASH CUTOUT