Switch off the main power supply first, Air venting, Changing the door hingeing – ASKO 7304 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Changing the door hingeing...
Switch off the main power supply first!
Tools: Phillip screwdriver, 10 mm wrench.
1. Remove the lower panel A.
2. Unscrew the upper screw B + C.
3. The upper hinge is now loose. Raise the door a little
so that it comes away from the bottom hinge.
Remove the top hinge.
4. Move the hinge pin J to the other hole in the hinge
using 10 mm wrench.
5. Push out the hinge bearings from the old holes in
the door.
6. Take the door apart by removing all screws which
are around the edge of the door.
7. Undo magnet cap D.
8. Remove the cover washer from the magnet position
E on the other side.
9. Screw the magnet tight at E (spring plus washer plus
screw) and insert cover washer in the hole at D.
10. Screw the door together.
11. Remove the plug from the new hole for the hinge at
the upper edge of the door at H. Insert this plug in
the old hinge hole.
12. Knock out the hole at the lower hinge hole K using a screwdriver. Insert the plug supplied in the old hinge hole.
13. Fit the hinge bearings in the new hinge hole.
14. Unscrew the lower hinge and move the hinge pin as shown in Item 5 above.
15. Remove the plastic protection at F and G and place this where the hinge was previously fitted.
16. Tighten the top hinge.
17. Screw in screw B for the bottom hinge a few turns.
18. Insert the lower hinge pin in the door hole. Place the door's top hinge hole on the upper hinge pin. Place the
door and the! lower hinge in position in screw B that has already been fitted. Screw in screw C.
19. Adjust the lower hinge so that the door hangs straight. Tighten screws B and C.
20. Refit the lower panel.
Air venting
There are three positions where the air evacuation
can be connected: at the rear, on the right hand
side and on the left hand side. When the machine is
supplied, one hole at the rear is open. The other
two are covered.
The tumble dryer is supplied with a stub pipe
and a plastic band. (A flexible hose must be
supplied by consumer.)
Fit the air evacuation as follows:
• Push the hose onto the stub pipe
and fasten with the plastic band.
• Remove the cover as necessary.
• Insert the stub pipe with
the hose into the hole.
• Fit the cover to the open hole.
WARNING — To reduce the risk of fire this appliance
MUST BE EXHAUSTED OUTDOORS or the equivalent.
If you want to change
the outlet:
• Remove the cover from
the hole where you wish
to fit the hose.
• Fit the stub pipe with
the hose connected
to it.
• Insert the stub pipe into
the new opening.
• Fit the cover to the hole
where the hose was
previously fitted.
10