Directed Electronics AVITAL 4003 - Manual (Page 8)

6 © 2009 Directed Electronics. All rights reserved.
When you are ready to drive the vehicle:
Insert the ignition key and turn it to the ON (not the START) posi- 1.
tion.
Press the brake pedal. The remote start system shutdowns but the
2.
motor continues to run because the ignition has been turned on.
The vehicle now operates as usual.
Note:
If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
While the vehicle is running during remote start operation, the system
monitors the vehicle and automatically shuts down the engine if the
system receives any of the following Shut-down inputs:
The brake pedal is pressed. •
The hood is opened. •
The shutdown toggle switch is put into the OFF position •
The pre-programmed run time has elapsed. •
The procedure to activate remote start is repeated. •
➢
Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful if you
want to exit and lock the vehicle for short periods of time, but would like
to leave the motor running and the climate controls on.