Accusplit Eagle 602M100D - Manual

z 602M100D (FY)
MULTI-FUNCTION STOPWATCH
STOPWATCH OPERATING INSTRUCTIONS
This watch has three modes-TIME, STOPWATCH,
and 3-STROKE/STRIDE MEASUREMENT. Press
the [MODE] button to cycle continuously through
these modes.
TIME MODE
To set current date and time ot day press [RESET]
button. SECONDS indicator will tiash to indicate you
are in SET mode.
Press [RESET] to cycle through and set each tield
(SECONDS -> MINUTES -> HOURS -> YEAR ->
MONTH -> DAY). Eield being set will tiash. Press
[START] button to set each tield.
STOPWATCH MODE
Event and Time-Out/Time-ln
Press [START]-Start timing
Press [STOP]-Stop timing (Time-Out, Display
shows “STOP”)
Press [START]-Start timing (Time-In)
Press [STOP]-Stop timing (Time-Out, Display
shows “STOP”)
Press [RESET]-Reset (Display Only)
Dual Split Memory with Split Counter
Press [START]-Start timing (Shows Running
CUM Time)
Press [LAP/SPLIT]-create 1st Split or Lap time
(Top row shows SPLIT 1, middle shows LAP 1,
and bottom row shows running cumulative time)
Press [LAP/SPLIT]-create 2nd Split (Top row shows
SPLIT 2, middle shows LAP 2)
Press [LAP/SPLIT]-create 3rd Split (Top row shows
SPLITS, middle shows LAP 3)
Press [LAP/SPLIT]-create 4th Split (Top shows
SPLIT 4, middle shows LAP 4)
Press [STOP]-Stop timing (Bottom shows Cumulative
elapsed time)
Press [RESET]-Reset display only (memories remain)
Notes:
Bottom row always shows Running Cumulative (CUM)
time. Split Counter shows the current Split being taken.
Last Split must be taken at end. Stop does not Split.
Memory Recall
While stopwatch is running:
Press [RECALL]-Recalls CUM time at last stop, or
last Lap/Split times.
Press [RECALL]-Recalls previous Lap/Split/Stop time
each time [RECALL] is pressed.
While stopwatch is stopped:
Press [RECALL]-Recalls CUM time at tirststop, or
tirst Lap/Split times.
Press [RECALL]-Recalls next Lap/Split/Stop time
each time [RECALL] is pressed.
RECALL Button
START
and
STOP
Button
-YEAR
■MONTH
and DATE
■TI ME
(24H)
Watch is
in TIME
OE DAY
MODE
MODE
Button
- Current
SPLIT
Time
■ Current
LAP
Time
■CUM
Time
Notes:
Hold down [RECALL] tor rapid review.
Whenever the storage is tull, “LULL” icon will be lit,
and extra Split times will not be stored into memory
(but will still be shown on the display). You can clear
the memories by stopping and resetting the watch.
3-STROKE/STRIDE MEASUREMENT MODE
In this mode you can tind Counts per Minute
(treguency) ot a swimmer’s strokes, a runner’s
strides, etc. Press [START] to start the measurement.
Atter you have observed THRLL strokes or strides,
press [STOP] to stop and display the Counts per
Minute (rate). NOTE: It the stroke treguency tails out
otthe range ot 10-180, “Lrr” will appear to show the
error condition. Press [RESET] to reset the displayed
reading to “0_0’i
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label on back of unit for details, or check
http://support.ACCUSPLIT.com
ACCUSPLIT, Inc.
6120 Stoneridge Mall Rd.
Suite 210
Pleasanton, CA 94588 USA
800-965-2008 • 925-226-0888
FAX 925-463-0147
www.ACCUSPLIT.com
[email protected]