Aiwa NSX-V2100 - Manual (Page 4)

CONNECTIONS 2 Connect the supplied AM antenna to the AM
LOOP terminal.
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is
120 V AC. Check that the rated voltage matches your local
voltage.
IMPORTANT
Connect the speakers, antennas, and all optional equipment first.
Then connect the AC cord in the end.
CAUTION!
Do not^connect the FM antenna to the outdoor antenna terminal
on the wall, as this could result in shock.
7 Connect the right and ieft speakers to the main
unit.
Connect the right speaker cord to the SPEAKERS R terminals,
and left to the SPEAKERS L terminals.
There are no differences between the front speakers. Both
speakers can be connected as L (left) or R (right).
The speaker cord with the white stripe should be connected
to the O terminal and the black cord to the O terminal.
3 Connect the AC cord to an AC outiet.
When the AC cord is connected, the all characters may light up
on the display. In this case, disconnect the AC cord. Then,
connect it again.
To position the antennas
FM antenna:
Extend fully and fix its end to the wall.
AM antenna:
Position to find the best direction.
' Be sure to connect the speaker cords correctly. Improper
connections can cause short circuits in the SPEAKERS
terminals.
■ Do not leave objects generating magnetism near the speakers.
' Do not bring the FM antenna near metal objects or curtain rails.
' Do not bring the AM antenna near other optional equipment,
the stereo system itself, the AC cord or speaker cords, since
noise will be picked up.
’ Do not unwind the AM antenna wire.
To connect other optional equipment -> page 14.
FM antenna
3
ENGLISH