Specifications bbe 802 – BBE Sonic Maximizer BBE 802 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Specifications BBE 802
Frequency Response
Bypass
Process Mode
Noise in Process Mode
Total Harmonic Distortion
in Process Mode
Input Characteristics
Input Impedance
Nominal Input Range
Maximum Input Level
Output Characteristics
Minimum Load Impedance
for full output
Nomimal Output Level
Maximum Output Level
Power Requirements
120 VAC (nominal) 50/60Hz
*See instructions below
A/C Line fused protected
Terminations/Connectors
Rear Panel
Dimensions
1 3/4" H
X
17" W
X
7 1/2"D
Weight
6 1 /2 lbs. (2.5Kgs)
NOTE; OdBu = 0.775 Vrms
Instructions for changing to 220 VAC Operation: Power is applied to the BBE 802 by means of the standard lEC line cord
provided. This cord may be used for 115 or 230 Volt Operation. There is a small plug-in circuit card underneath the fuse on the
rear panel. This card must be turned so that the line voltage being used is visible through the plastic window.
ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
DC to 20kHz
program controlled
-90dBu below OdBu output level
less than 0.15% @ 1kHz. @ -(-4dBu
15K Ohms (balanced or unbalanced)
-10dBu to -t-8dBu for best operation
+
24dBu (input clip point)
600 Ohms (balanced or unbalanced)
-10dBu to -i-8dBu
H- 24dBu into 600 Ohm Load (clip point)
8 Watts (switchable to 220 VAC)
XLR and 1 /4" Tip-Ring-Sleeve (Tip is hot)
Standard 1U single rack