Boss Audio Systems MR100 - Manual (Page 3)

Woofer Installation Instruction
^ ^ ^
1. Using mounting template for woofer,
mark the correct mounting loaction by
a pencil or pen.
2. Cut out the panel by this marking and
drill 6 holes for the mounting bolts to
pass through.
3. Rotate the plastic grill counterclockwise
to separate it from the woofer.
4. Connect the terminal of the speaker to
car audio correctly by using cord provided.
Caution; Be carefuly not to misconnect
polarity.
5. Insert woofer in the speaker mounting
hole and fix woofer with bolt & screws
& nuts provided.
6. Put the plastic grill back with the
woofer, rotate it clockwise.
Thank you for purchasing BOSS speaker systems. Engineered in the
USA, BOSS offers innovative products that are on the cutting edge of de­
sign and performance.
If you have any question about the installation or operation of your
BOSS
speaker system which are not answered by this manual, contact your dealer
in first instance.
Precautions
• Before making holes, check the mounting space with supplied template
• To prevent noise pick-up, keep the wiring of this unit away from motors,
high-voltage leads and other possible noise, source.
• To prevent short-circuit, keep all wiring away from moving parts sharp edges.
• Make sure you have carefully read and understood the installation instruction.
10” Marine Subwoofer
(SOOwatts RMS Sealed Enclosure)
HIGH QUALITY POLY MICA CONE
BUTYL RUBBER SURROUND
WATER-RESISTANT CONSTRUCTION
2” HIGH TEMPERATURE VOICE COIL
600 WATTS PEAK / 300 WATTS RMS
FERQUENCY RESPONSE: 30 HZ - 2.5 KHZ
SPL: 9 4 d B ( 1 W / 1 M )
IMPEDANCE: 4 OHMS
MOUNTING DEPTH: 4-5/8”