Engine maintenance, Note – Bolens 248-604A User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
E. Clean and reassemble using a hydraulic sealant
on the threads.
ENGINE MAINTENANCE
To obtain long life and trouble-free service from your
engine,
certain
normal
maintenance
must
be
performed as outlined below:
1.
Change oil in crankcase after first two (2) hours
of operation. Then, follow instructions outlined
on page 5.
FIGURE 17
A
CAUTION
Disconnect high tension wire at spark
plug
to
prevent
accidental
starting
of engine. Unscrew oil drain plug
located on side at bottom of engine
See figure 17.
NOTE
Always tip engine towards oil drain
hole. Be sure oil drains completely.
Replace oil drain plug and refill with oil as directed
on page 5 or engine nameplate.
2. Check oil every five (5) operating hours or each
time equipment is used.
3.
Cleaning engine—This is an aircooled engine which
operates most efficiently when the cooling fins
are clean.
Clean cylinder fins and underside of tank or housing
thoroughly of all accumulated grass and debris.
4. Air Cleaner. (See figure 18.)
a. Paper Type Element. Remove every 10 hours or
oftener if under dusty conditions. Tap to remove
loose dirt and/or blow from inside out with low
pressure air. Replace if torn or perforated or
when
plugged
to
maintain
proper
carburetor
setting (50 hours). DO NOT WASH IN ANY
LIQUID AND DO NOT OIL.
FIGURE 18
CARBURETOR ADJUSTMENTS (See figure 19)
Do not make unnecessary adjustment. Factory
settings are correct for most application. If
adjustments are needed, proceed as follows:
1.
Close power adjusting needle (figure 19) by
turning to right (clockwise). Close finger tight
only. Forcing will cause damage.
2. Open one turn (counterclockwise).
3.
Close idle adjusting needle (figure 19) by turning
to
right
(clockwise).
Close
finger
tight
only.
Forcing will cause damage.
4.
Open one and one-half (1-1/2) turns (counter
clockwise).
Start engine. Follow starting instructions page 5.
5.
6
.
With throttle open (carburetory control at RUN
or FAST position) adjust power adjusting needle
one-eighth (1/8) turn at a time forward to back
ward until engine runs smoothly. If engine tends
to
stall
under
load
enrich
mixture
slightly
(counterclockwise).