Amana Pi143415N - Manual (Page 3)

Component Testing Information
A WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless
testing requires it.
Illustratiort Component Test Procedure Results
053584 Control limit Normally Closed
Verify proper operation.
Closed 245°F
Open 275“F
Continuity
Infinite
If open at room temperature, replace.
31715201— LH
31715202— RH
Opening
Hinge Carefully open the hinge fully, and
insert a wooden dowel or screwdriver
bit into opening.
Remove top and bottom screws
securing hinge.
Slide hinge top towards rear of unit
and guide hinge out through frame
opening or storage drawer.
A CAUTION
Do not place hands in hinge area when
oven door is removed. Hinge can snap
closed and pinch hands or fingers.
065780 Door lock switch Switch connection in following
positions:
Unlocked
Locked
Set ERC to Clean
COM-NO=Open, COM-NC=Closed
COM-NO=Closed, COM-NC=Open
Lock LED should flash
Lock LED and Oven LEO should
illuminate, If Lock LED does not
illuminate, check switch and wiring.
305797 Door plunger switch Remove switch from unit and measure
the following points:
C-NC
C NO Plunger in infinite. Plunger out continuity.
Plunger in continuity, Plunger out infinite.
31797301 Autolatch assembly
with door plunger
switch
Disconnect wires and test for
continuity per diagram. NC NC
LI L2 COMI PM com ! no
X ■ I' Jr >L i
120 VAC LedVUntocfc
Motor
Door
Switch
April 1999 RT2320003 Rev. 9