Smartek ST-X500 - Manual (Page 16)

Steam press Instruction Manual Page15
TROUBLE SHOOTING THE STEAM PRESS
Below is a chart detailing the most common problems, their causes and solutions. Before shipping any appliance to a service center Please check to make
sure that the solution is not listed here:
PROBLEM CAUSE SOLUTION
Steam Press Cannot Be Opened Using
Pressing Handle.
Locking Knob is in Locked Position.
Turn the Locking Knob to the Unlocked
Position.
Steam Press Becomes Warm but DOES
NOT Remove Wrinkles. Temperature Setting is not high enough for
the fabric attempted. Gradually increase the temperature until
obtaining the desired results.
Press DOES NOT get warm. Temperature has not been selected.
Press is not plugged into an outlet.
Automatic Shut-Off has engaged. The
Pressing Plate has been lowered for more
than 15 seconds without being raised.
Automatic Shut-Off has engaged. The
Pressing Plate has been raised for more than
15 minutes without use.
Turn the Temperature Control Dial to an
appropriate setting.
Plug the appliance in.
Push the ON/OFF switch to the OFF position
and back to ON. Raise the Pressing Plate
during the warm-up period.
Push the ON/OFF switch to the OFF position
and back to ON. Raise or lower the Pressing
Plate to restart the heater.