Sceptre X420BV-FHD - Manual (Page 12)

- 12 -
www.SCEPTRE.com
SCEPTRE X42 HDTV User Manual
Rear View Connections
1. USB – USB connects to USB flash drives for playing music and picture. The USB port is
also used for updating the TV’s firmware.
2. HDMI1 – HDMI connects to devices that use HDMI cable, such as Blu-ray or HD DVD
player, or HD cable / satellite set-top box. This connection port receives pure digital
audio and high definition signal through one single cable. This port also can accept a
HDCP video device for video.
3. HDMI2 – Refer to HDMI1.
4. HDMI3 – Refer to HDMI1.
5. Audio In - This connection port is for people who want to provide audio to the TV when
using a PC or a DVI video device. The sources use 3.5mm mini-jack audio cable.
6. VGA - This connection port connects to a PC for video using VGA cable. Be sure to
connect your audio cable to the VGA Stereo input if you want sound out of VGA video
source.
7. YPbPr 2 – This connection port is for DVD players or satellite / cable set-top boxes that
use component cables. From left to right, connect green, blue, and red for video, and
then connect red for right channel audio, and white for left channel audio
8. YPbPr 1 – This connection port is for DVD players or satellite / cable set-top boxes that
use component cables. From left to right, connect green, blue, and red for video, and
then connect red for right channel audio, and white for left channel audio. This
connection shares audio red / white jacks with the source VIDEO.
9. LR – This connection is for audio shared between the sources YPbPr1 and Video.
10. Video – Video connects to devices that use composite video cables such as VCR or
DVD player or Wii™. Connect the yellow for video and the red / white for audio.
11. Audio Out – This connection is for sending out analog audio signals to surround sound
receivers. Connect the red for right channel audio out and white for left channel audio
out.
12. SPDIF - This connection port is used for sending out digital audio signals to digital
surround sound receivers. The orange (COAX SPDIF OUT) connector sends out either
bit-stream or PCM digital sound signal to a home theater receiver with digital coax input.
13. HEADPHONE – This connection is for headphones to be attached to the TV.
14. TV – This connection is for digital or analog cable without the cable box or over-the-
airwave antennas. The tuner is a hybrid tuner that tunes to both analog and digital
channels. This connection uses coaxial RF cable. For over-the airwave digital stations
please check
http://www.antennaweb.org .
Please Note:
• This TV features a power saving function which will turn off the TV automatically
after 10 minutes of idling on a connection with no signal. This feature is present on
all connection.