Intex AUTO POOL CLEANER - Manual (Page 8)

(198PO) AUTO CLEANER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 06/18/2013
S AVE THESE INSTRUCTIONS
English
198
PO
LONG TERM STORAGE
1. Make sure the filter pump is turned off, and disconnect the power cord
from the electrical outlet.
2. Using the Set Up instructions in reverse, disassemble the auto cleaner.
3. Clean and air dry all the accessories and parts thoroughly.
4. Keep the hoses straight during storage.
5. Remove the brushes and keep them flat and straight during storage.
6. The original packaging can be used for storage. Store in a dry, cool
storage location.
Page 8
TROUBLESHOOTING GUIDE
If you continue to experience difficulty, please contact our Consumer
Service Department for assistance. See separate “Authorized Service
Centers” sheet.
IMPORTANT
Q. What should I do if Auto Cleaner doesn’t move or movement is very
slow?
A. 1. Pull the cleaner’s hose and lift auto cleaner off from the wrinkles.
2. Check the circulation line:
i. Ensure the filter pump is turned on.
ii. Ensure the plunger valves are opened.
iii. Clean or replace cartridge.
iv. If using a sand filter, ensure the sand media is clean by
backwashing it.
Q. What should I do if Auto Cleaner lifts off from the pool floor?
A. Release air from the auto cleaner by following the “Owner’s Manual”.
Q. What should I do if the Auto Cleaner can not pick up the leaves from
the pool floor?
A. 1. Remove the brushes from the underside and put the Auto Cleaner
back into the pool.
2. Clean all the debris from the Auto Cleaner after running for 2-3
hours continuously.