Intex WL3110 - Manual (Page 6)

(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 04/28/2013
English
SAVE THESE INSTRUCTIONS
155
PO
Page 6
SETUP INSTRUCTIONS (continued)
Installation on Intex Sequoia Spirit Wood-Grain Pools:
Unscrew the bolts from the section where the LED pool-wall light will be installed, and remove the
clamp covers, the top board and the side boards. Refer to the Wood-Grain Pool owner’s manua
for details. For better installation, it is recommended to remove at least 3 side board panels. Follow
above setup instructions 1 to 4.
LONG TERM STORAGE
In areas where freezing temperatures occur, there is risk of ice damage to the product. It
is recommended to remove, clean and store the product in a safe place when temperature
drops below 0 degrees Celsius (32 degrees Fahrenheit).
1. Unplug the power cord from the electrical socket.
2. Remove the transmitter (2) from the outside of the pool wall first, the pool light (1) unit will
automatically float to the surface for easy retrieval, then remove the pool light from the water.
IMPORTANT: To prevent damage to the transmitter from falling to the ground, always
remove the transmitter first before removing the pool light unit.
3. If deposits or debris are seen inside the holes of the pool light, use a garden hose to flush them
out. Do not scrape the pool-wall light or use brush to clean it.
4. Thoroughly air-dry all components before storage.
5. Store the product and accessories in a dry, temperature controlled location between 32 degrees
Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius).
6. The original packaging can be used for storage.
4 5