Intex 637R Krystal Clear 2014 - Manual (Page 5)

(105) MODEL 637R FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/21/2013
105
SAVE THESE INSTRUCTIONS
English
Page 5
SETUP INSTRUCTIONS
Be sure you have access to water to fill the pool and chemicals for the water. A small coin
can be used to tighten the hose clamps (7).
IMPORTANT: This filter pump is shipped with the air release valve (1) open (open the
air release valve if necessary). DO NOT replace the air release valve until you reach
STEP #8. Failure to follow these instructions will result in air trapped inside filter
housing; the motor will run dry, be noisy and malfunction.
1. Assemble above-ground-pool first. Carefully follow the pool’s installation instructions.
2. Place the filter pump the length of the hose away from the pool wall where the lower
black protruding hose connection is "sticking-out".
3. Insert the nozzle union (9 & 10) into the upper protruding hose connections. Then insert
the strainer union (9 & 11) into the lower protruding hose connections. The hoses (8) fit
over the strainers inserted into the connections.
4. There are two hoses to be connected to the filter pump hose connections. With hose
clamps
(7), fasten one of the hoses (8) to the lower protruding hose connection (marked
"+" on the pool liner) and to the upper pump connection (marked "+").
5. Connect the second hose to the remaining upper protruding hose connection and to the
lower pump connection. Make sure all the hose clamps (7) are tight.
6. Twist the filter pump’s threaded cover (3) in a clockwise direction to be sure it is on
"tight". Use only your hands to tighten the top. Do not tighten with tools such as pliers.
7. Fill the pool to a level of at least 1-2 inches above the top connection. The water will
automatically flow down into the pump.
8. When water starts flowing out of the air release valve hole, screw in the air release valve
back into the filter housing cover. Do not over tighten the valve. NOTE: Venting the
system is necessary for air to escape as the filter housing fills with water.
9. Connect the filter pump to the power outlet. The filter pump is now filtering the water.
Risk of electric shock. Connect this product only to a grounding type receptacle
protected by a ground-fault circuit interrupter (GFCI). Contact a qualified electrician
if you cannot verify that the receptacle is protected by a GFCI.
WARNING
10. Operate the filter pump until the desired water clarity is obtained.