Interlogix KTD-400 - Manual (Page 21)

17
Keypad operation
When power is first supplied to a KTD-400 series keypad, the LCD display will briefly display the company
name, and then show the normal operating display (Figure 36).
Figure 36. KTD-400 normal operating display
From this display and by observing the system’s monitors, you can use the function keys for control.
Monitor selection
To select a monitor, press Mon and use 0 through 9 to enter the desired number. For example to select monitor
12, press Mon, 1, 2. All video switching operations will now be done on the selected monitor.
Camera selection
To select a camera, use 0 through 9 to enter the desired number. For example, to select camera 345, press 3, 4,
5. The camera associated with the site will appear on the selected monitor, and all keys applicable to that site
will become operational.
Engaging autofocus on CyberDomes
To engage autofocus on CyberDomes, press and hold Auto for one second. Use Focus near or Focus far to
disengage.
Finding a preset
To find a preset, select the desired camera, press Set and use 0 through 9 to enter the preset number. The entry
may be one or two digits depending on the largest preset position programmed in the keypad setup. For
example, to preset 6, press Set, 6.
Note: The preset option referred to in this section will function only if activated during setup.
Preset tours
To activate a camera’s preset tours or ShadowTour, select the desired camera and press Set, Auto, and the tour
number (1 through 4). On older CyberDome models, only one preset tour could be programmed. Entering any
tour number will activate the preset tour. To deactivate the tour, press an arrow key.
CAMERA 000
MONITOR 01