Haltech F10X - Manual (Page 11)

F10X Manual
11
SECTION 1 Getting Started
CHAPTER 1 HALTECH ECU INSTALLATION
1.1 The ECU and Associated Hardware
The Haltech F10X system comprises the following components
Haltech Electronic Control Unit (ECU)
Main Wiring Harness
Haltech F10X system Instruction Manual
Programming Cable
Programming Disk
Relays
1.2 Installation Summary
The Following is a list of the procedures that will be followed in the installation of the ECU.
1. Mount Manifold Absolute Pressure Sensors.
2. Mount Coolant Temperature Sensors.
3. Mount Inlet Air Temperature Sensors.
4. Mount Throttle Position Sensors.
5. Mount optional Exhaust Gas Oxygen Sensor (if used)
6. Route Main Wiring Harness and connect sensors.
7. Mount and connect Power Relays.
8. Mount Fuse Block.
9. Mount ECU inside passenger compartment.
10. Locate and connect flying wires:
RED + 12 volts battery
GREY Ignition on 12 volts
BLACK Chassis ground
ORANGE (2 wires) Fuel Pump Circuit
11. Install and connect the optional Idle Speed Motor
12. Install and connect any Optional Outputs
13. Connect Trigger signal
14. Connect ECU and test.