FingerTec DiGiTime (OEM) - Manual (Page 7)

6 CONTENTS
[2] Select the model of the terminal.
[3] Select Type of Connection
• TCP/IP if using LAN connection.
• COM1~6 if using RS232 or RS485 connection.
• USB if using USB flash disk to transfer data .
[4] Select the baud rate if COM1~6 is selected as Types of Connection. Ignore if TCP/IP or USB
is selected as Types of Connection.
[5] Insert the IP address of the terminals. Ignore if COM1~6 or USB is selected as Types of
Connection (same settings in Communication Option in the terminals).
[6] Uncheck the Disable column to connect the software to the terminals.
Step 2: A message will pop up and request you to confirm that the terminal has been con-
nected properly. Click “Okay” after you have checked the connection.
Step 3: A new window will pop up to
indicate that connection is established.
The software will connect to the termi-
nal to read the serial number. Insert the
Activation Key into the column. Click
“Apply” to save settings.
The software has been activated and it is ready to run. Click “OK” to accept the message.