Buttonhole making – Kenmore 1030 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
J."
■T|B|
BUTTONHOLE MAKING
SETTINGS
Stitch Width Control - 4
Stitch Length Control - Red Zone
Zigzag Presser Foot
Use zigzag stitching plate.
1.
Carefully mark the position and
length of each buttonhole on your
garment.
Select
the
proper
size
buttonhole
guide
foot
to
corre
spond with the length of button
hole.
2.
Mount the guide foot onto the
presser
foot.
Holding
on
to
the
top
thread,
rotate
the
handwheel
toward
you
one
complete
turn.
Pull the upper thread under and
to
the
back
of
the
buttonhole
guide foot. See Figs. 1 & 2.
3.
Note in Fig. 3 that each guide
foot has a dot on the right edge
toward the back of the foot, and
on the left edge near the front of
the foot. These dots are used as a
point of reference for your bartack-
ing
steps
in
buttonholing.
(See
next page).
4.
Slide the guide foot forward until
the rear edge of the presser foot
is at the rear edge of the guide.
5.
Place the fabric with the marked
buttonhole
under
the
guide
foot.
Lower the presser foot lever and
follow steps on next page.
(Check
Hints
for
Perfect
Button
holes on Page 32.)
30