Soak, Permanent press i, Permanent press ii – Kenmore 11025854400 User Manual
Page 2: Ultra clean, Prewash, Rinse a spin, Spin only, Automatic sid rinse
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cy€:B
;; :'i■i■;íler|
C€wÉml
Soak
Permanent Press I
A load cooling spray rinse reduces wrinkling.
Permanent Press II
During the wash cycle, the timer reaches PAUSE, and the washer
coots down the load by replacing some of the wash water with
rinse water. This helps to reduce wrinkling.
Ultra Clean
You may select this cycle for most loads.
Prewash
Helps to remove heavy soils and stains that need pretreatmeni. This
cycle should be followed by an Ultra Clean or Permanent Press
cycle with additional detergent.
Features agitation followed by unlimited soak time to help
remove heavy soils and stains that need pretreatment. After the
soaking has finished, you should reset the washer to a Spin
setting to remove water. The Soak cycle should be followed by an
Ultra Clean or Permanent Press cycle with additional detergent.
Rinse a Spin
May be used when an extra rinse is needed to remove additional
detergent residue. Set WATER LEVEL Control, then WATER
TEMPERATURE Control. Set RINSE OPTIONS Control to One
Rinse, and set the SPEEDS Control. You should then set Cycle
Selector (Timer) Control to a Rinse setting.
Spin Only
A drain and spin may help shorten drying times for some fabrics
by removing excess water. Set RINSE OPTIONS Control to One
Rinse, and set the SPEEDS Control. You should then set Cycle
Selector (Timer) Control to a Spin setting.
Automatic Sid Rinse
Removes excess detergent residue. May be automatically added
to the Ultra Clean or Permanent Press cycles. Set the RINSE
OPTIONS Control to 2nd Rinse before you start the washer. You
won’t have to come back later to select a second rinse.