Warmer drawer, To remove and replace warmer drawer, To remove warmer drawer – Kenmore 790.492 User Manual
Page 9: To replace warmer drawer, Avoid service checklist, Generai cleaning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Generai Cleaning
(continued)
ik WARNING
Turn the warmer drawer
control knob to OFF before removing
the drawer. DO NOT touch the warmer
drawer element. The element may still
be hot enough to cause burns, even if
it is dark in color.
Push down latch
with finger
Right Glide
Warmer Drawer
To Remove and Replace Warmer Drawer
To Remove Warmer Drawer:
^WARNING
¡Turn power off before removing the warmerdrawer.
2. Open the drawer to the fully opened position.
3. Locate the latches on both sides of the warmer d rawer.
4. Pull up on the left glide latch and push down on the right glide latch.
5. Pull the drawer away from the appliance.
6
. To clean warmer drawer, gently scour with a soapy scouring pad, this
will remove most spots. Rinse with a 1:1 solution of clear water and
ammonia. If necessary, cover difficult spots with an ammonia-soaked
paper towel for 30 to 40 minutes. Rinse with clean water and a damp
cloth. Remove all cleaners orthe porcelain may become damaged
during future heating. DO NOT use spray oven cleaners on the
cooktop.
To Replace Warmer Drawer:
1
. Align the glide latches on both sides of the drawer with the slots on
the drawer.
2
. Push the drawer back into the appliance.
ik WARNING
Electrical Shock Hazard can occur and
result in serious injury or death. Disconnect appliance
from electric power before cleaning and servicing the
warmerdrawer.
Avoid Service Checklist
Before you call for service, review this list. It may save you time and expense.
The list includes common occurrences that are not the result of defective
workmanship or materials in this appliance.
OCCURRENCE
POSSIBLE CAUSE/SOLUTION
Drawer is not level.
Poor installation. Place a level on the cutout bottom. Make sure bottom is level.
Be sure cutout bottom is strong and stable enough to adequately support drawer
(and wall oven, if applicable).
Cannot move appliance easily.
Appliance must be accessible for
service.
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
Warmerdrawer does not operate.
Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Contact Sears or another qualified servicer.
Power outage. Check house lights to be sure. Call your local electric company
for service.
9