Kenmore ELECTRIC RANGE 790.4660 - Manual (Page 35)

Seif-Cleaning (confd)
Self-Clean Cycle Time Length
The FLEX CLEAN pad is used to start a Self-Cleaning cycle. When used with the DELAY START pad, a
delayed Self Cleaning cycle may also be programmed. The FLEX CLEAN feature allows for any Self-Cleaning cycle time
from 2 (2:00) to 4 hours (4:00) to be selected. You may also choose the clean time in 1 minute increments (for example 2
hours and 50 minutes) by pressing the number keypads (DCD®.
A CAUTION
A CAUTION
I During the Self-Cleaning cycle, the outside of the range can become very hot to the touch. DO NOT leave
small children unattended near the appliance.
I DO NOT force the oven door open. This can damage the automatic door locking system. Use care when
opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot airor
steam to escape. The oven may still be VERY HOT.
INSTRUCTIONS PRESS DISPLAY
To set an immediate Self-Cleaning Cycle or to set a delay start time of
9:00 o’clock (example: default 3 hour Self-Clean cycle):
1. Be sure the clock is set with the correct time of day, the oven is
empty and the oven door is closed.
Press i
CLEAN
"CLEAN" will flash and "3:00" HR will show in the
display (Figure 1). 2-4 hours of Self-Cleaning time may be chosen
by pressing any amount of time from ®(2)Co) (2 hours)
through (4 hours) in one minute increments.
You may also skip the time entry and accept the default cleaning
time of 3 hours by pressing the Start key pad (See Step 3).
3. Press (STARy."DOOR", "LOCKED" will flash; "CLEAN" and the
/T le TN
\Cl£At^
:■ ■■ B - n n " Cl
Figure 1
OOOR LOCKËD CLEAN ' ...
Figure 2
4.
letters "CLn" will remain on in the display (Figure 2).
As soon as the control is set, the motor driven oven door lock will
begin to close automatically. Once the door has been locked the
"DOOR", "LOCKED" indicator light will quit flashing and remain on.
Note: Allow about 15 seconds for the oven door lock to close.
Note: If the optional delay Self-Clean feature is needed, finish steps 5-7. if Self-Clean is started immediately skip
the remaining steps and continue with “When the self-clean cycle is completed” on the following page.
5. Press (JjARy (see Figure 3). Enter the desired Self-Clean starting
time using the number pads (See figure 4).
Pressdr^. "DELAY", "DOOR", "LOCKED", "CLEAN" will 6
.
7.
remain on and the display returns to the time of day.
Based on the time amount you selected in step 2, the control will
calculate forward from the set start time to determine when the
Self-Cleaning cycle should end. The Self-Cleaning cycle will turn
on automatically at the set time. At that time the icon "DELAY"
will go out; the oven icon will come on, "CLEAN" and "CLn" will
remain in the display (see Figure 5).
When the Self-Clean Cycle is Completed
1. The time of day, the 'DOOR", "LOCKED" and "CLEAN icon will
remain in the display.
2. Once the oven has cooled down for approximately 1 HOUR, and
the "DOOR", "LOCKED" icon is no longer displayed, the oven door
can then be opened.
35
n n n
U-PU
Figure 3
3-00
iln
Figure 4
g .fin
■UP L L n
Figure 5