beautypg.com

Operating instructions (cont’d), Temperature regulation, Awarning – Kenmore POWER MISER 153.330551 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Operating Instructions (cont’d)

Temperature Regulation

Due to the nature of the typical gas water heater, the water tem-

erature in certain situations may vary up to 30°F higher or

ower at the point of use such as, bathtubs, showers, sink, etc.

f

Ic
This means that when the temperature adjustment dial is set at

the mark approximating 120°F, the actual water temperature at

any hot water tap could be as high as 150°F or as low as 90°F.

Any water heater’s intended purpose is to heat water. Hot water

is needed for cleaning (bodies, dishes, clothing). Hot water will

present a scald hazard. Depending on the time element, and the

people involved (normal adults, children, toddlers, elderly,

infirm, etc.) scalding may occur at different temperatures.

AWARNING

HOTTER WATER CAN SCALD: Water heaters are intended to
produce hot water. Water heated to a temperature which will
satisfy clothes washing, dish washing, and otiW sanitizing needs
can ^d and permanently injure you upon contact Some peo­

ple are more likely to be permanently injured by hot water than
others. These include the elderly, children, the infirm, or physical-
ly/mentally handicapped. If anyone using hot water in your home
to into one of these groups or if there is a local code or state law
requiring a certain temperature water at the hot water tap, then
you must take special precautions. In addition to using the lowest

possible temperature setting that satisfies your hot water needs,

a means such as a mbdng valve, should be used at the hot water
taps used by these people or at the water heater. Mbdng valves

are availaUe at plumbing supply or hardware stores. Follow man-
ufocturers instructions for installation of the valves. Before
changing the factory setting on the thermostat, read the
“Temperature Regulation” section in this manuai.

AWARNING

Never allow small children to use a hot water tap, or to draw
their own bath water. Never leave a child or handicapped per­
son unattended in a bathtub or shower.

The thermostat of this water heater has been factory set at its

lowest position, to reduce the risk of scald injury. It is adjustable

and must be reset to the desired temperature setting. The mark

(A)

indicative of approximately 120“F is the preferred starting

point. Some states have a requirement for a lower setting. If you

need hotter water, follow directions for temperature adjustment,

but beware of the warnings in this section.

Turn the water temperature dial clockwise %) to decrease

the temperature, or counterclockwise ^) to increase the

temperature.

PILOT

LIGHTING Set here before lighting pilot.

A

- Is a thermostat setting of approximately

120”F, which will supply hot water at the

most economical temperatures. The tempera­

ture adjustment knob can be turned lower

than 120°F if desired.

A - Is a thermostat setting of approximately

130-F.

B - Is a thermostat setting of approximately

140”F.

C - Is a thermostat setting of approximately

150“F.

VERY HOT — Is a thermostat setting of 160“F, It is recom­

mended that the dial be set lower whenever

possible,

NOTE: Water temperature range of 120“—140“F recom­

mended by most dishwasher manu&ctuters.

AWARNING

Should overheating occur or the ga$ supply fall to shut off,
turn “OFF’ the manual gas control valve to the appliance.

19

This manual is related to the following products: