Kenmore ASPIRADORA 116.35913 - Manual (Page 20)

Review this table to find do-it-yourself solutions for minor performance problems. Any service
needed, other than maintenance described in this Owner's Manual, should be performed by a
Sears or other qualified service agent.
A
WARNING:
Disconnect electrical supply before performing maintenance to the unit. Failure
to do so could result in electiicaJ shock or personal Injuiy.
pwmm >0^iBLE$0ml10N
Vacuum cleaner
won't run. 1. Unplugged at wall outlet.
2. Tripped circuit breaker/blown fuse
at household service panel.
3. Thermal protector tripped.
4. Defective wall outlet.
1. Plug in firmly, select the desired set­
ting on the touch control.
2. Reset circuit breaker or replace fuse.
3. Allow vacuum cleaner to cool, then
reset thermal protector.
4. Check with a good appiiance/lamp,
have property serviced.
Poor job of dirt
ptdc-up. 1. Full or clogged dust bin.
2. Wrong pile height setting.
3. Worn agitator.
4. Clogged nozzle.
5. Clogged hose,
a Hole in hose.
7. Hose not inserted fully.
8. Motor protection system activated,
(change of sound)
9. Dirty filters.
1. Empty dust bin.
2. Adjust setting.
3. Take to your nearest Sears
Service Center,
4. Check CLOG REMOVAL.
5. Check lor clogs.
8. Take to your nearest Sears
Service Center.
7. insert hose fully.
8. Check for clogs.
8. Change filters.
Vacuum Cleaner picks up
moveable rugs or
pushes too hard. 1. Wrong pile height setting. 1. Adjust setting.
U^t wont work. 1. Burned out light bulb. 1. Change light bulb.
Agitator does not turn. 1. Handle in full upright position.
2. Agitator Overload tripped.
3. Thermal protector tripped.
1. Move handle from upright position.
2. Reset Agitator Overload.
3. Allow vacuum to cool, then reset
thermal protector.
Mrfkw restricted
w№ attadimant use.
Sound changes.
1. Attachment use restricts air flow.
2. New carpet fuzz clogged air path.
1. Check ATTACHMENTS for fuzz, tint,
pet hair or other debris.
2. Check CLOG REMOVAL and clean
hose.
Difficulty ac^ustlng pile
height setting 1. Vacuum cleaner not in proper upright
position.
1, Place vacuum cleaner in the locked
upright position, tilt the vacuum back
sfightly and adjust pile height.
20