Whirlpool BES750W - Manual (Page 4)

Using Your Oven
The electronic oven controls
There are three parts in the oven control
section:
- The digital display.
- The command buttons.
- The Time/Temp Set Knob.
Instructions for each oven control are
covered on the following pages. Read
them carefully.
When you first plug in the oven, the
display will flash the last time of day set.
If, after you set the clock (see below) the
display again flashes the last time of day
set, your electricity was off for a while.
Reset the clock.
Digital display/clock
DELAY
OVEN ON
CLEAN
STOP
TMER
'UUcitii, Ksi I
When you are not using the oven, this is
an accurate digital clock. When using
the oven or Minute Timer, the display
will show the time, temperature settings
and what command buttons have been
pressed.
When showing the time of day, the
display will show the hour and minutes.
When setting the Minute Timer, the
display will show minutes and seconds
as follows:
■ For settings from 0 minutes to 1
minute 55 seconds, the display will
increase in 5-second increments.
■ For settings from 2 minutes to 9
minutes 50 seconds, the display will
increase in 10-second increments.
■ For settings from 10-59 minutes, the
display will increase in 1 minute
increments.
■ For settings from 1 hour to 1 hour
55 minutes, the display will
increase in 5-minute increments.
■ For settings from 2 hours to 9 hours
50 minutes, the display will
increase in 10-minute increments.
When using Cook Time, the display
shows hours and minutes.
W SBWMM
b
Command buttons
The command buttons tell the oven what
to do and in what order. A few
examples:
- Clock tells the oven you are going to
set the clock.
- Set/Cancel tells the oven to turn off.
Each command button (except Set/
Cancel) has its own indicator. The
indicator comes on when you touch the
command buttons.
Time/Temp Set Knob
TIME/TEMP
SET
Once you’ve pushed a command button
to tell the oven what you want it to do,
you'll use the Time/Temp Set Knob to set
a temperature or time. Turning the
Time/Temp Set Knob clockwise
increases the number on the display.
Turning the Time/Temp Set Knob
counterclockwise decreases the number
on the display.
Setting the electronic clock
Using the electronic Minute
Timer
The Minute Timer does not start or stop
the oven. It works like a kitchen timer. It
can be set in minutes and seconds or
hours and minutes up to 9 hours, 50
minutes. You will hear three beeps when
the set time is up.
1. Push the Timer button. The TIMER
indicator will come on and the large
display will show “ :00".
2. Turn the Time/Temp Set Knob until
the desired time shows in the large
display. The Minute Timer will
begin counting down 2 seconds
after the time is set.
When time is up, you will hear
three beeps and the time of day
will show in the large display. After
the first three beeps, you will hear
one beep every 10 seconds until
you push the Set/Cancel button.
To cancel the Minute Timer:
■ Push the Timer button and turn the
Time/Temp Set Knob until " :00”
shows in the large display.
■ Do not push the Set/Cancel button
(see below) or it will cancel any
bake or broil program that has been
set.
Using the Set/Cancel button
1. Push the Clock button. The TIME
indicator will show in the display.
2. Turn the Time/Temp Set Knob until
the correct time shows in the large
display.
3. Push the Set/Cancel button to start
clock operation.
The Set/Cancel button will cancel any
command except for times set with the
Timer button. When the Set/Cancel
button is pushed, the large display will
show the time of day or, if Minute Timer
is also being used, the time remaining.
Page 4