Buick 2010 Enclave - Manual (Page 231)

Infotainment System 7-53
3. Say the name tag of the person
to call.
. If the system clearly
recognizes the name tag it
responds with “OK, calling,
” and dials the
number.
. If the system is unsure it
recognizes the right name
tag, it confirms the name
tag followed by a tone.
If the name tag is correct,
say “Yes”. The system
responds with “OK, calling,
” and dials the
number. If the name tag is
not correct, say “No”. The
system will ask for the
name tag to be re‐entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re‐dial Command
1. Press and hold
b g
for
two seconds. The system
responds with “Ready” followed
by a tone.
2. After the tone, say “Re‐dial”. The
system responds with “Re‐dial
using ” and dials
the last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
. Press b g and begin speaking
to answer the call.
. Press
c x
to ignore a call.
Call Waiting
Call waiting must be supported on
the Bluetooth phone and enabled by
the wireless service carrier to work.
. Press
b g
to answer an
incoming call when another call
is active. The original call is
placed on hold.
. Press
b g
again to return to the
original call.
. To ignore the incoming call,
continue with the original call
with no action.
. Press
c x
to disconnect the
current call and switch to the call
on hold.