AquaCraft Wildcat - Manual (Page 3)

3
THE USE, MISUSE OR INABILITY TO USE THE PRODUCT OR FROM
DEFECTS IN THE PRODUCT. This warranty gives you specifi c legal
rights and you may also have other rights, which vary from state
to state.
Outside USA and Canada, contact the local importer for warranty
information.
HOBBY SERVICES Ph: (217) 398-0007
Attn: Service Department 9:00 am - 5:00 pm
3002 N. Apollo Drive, Suite 1 Central Time M-F
Champaign, Illinois 61822
E-mail: [email protected]
SAFETY PRECAUTIONS
● Never ever attempt to swim after a stalled RC boat. Do not get
in the water for any reason to retrieve your boat. To aid you in
retrieving a stalled RC boat, set up a fi shing reel with a tennis
ball tied to the end of the line. Or better yet, get yourself a small
Jon boat so you can row out and pick up your boat. Remember
to use a PFD any time you enter your retrieval craft.
● AquaCraft products are to be used by ages 14 and over.
● Do not touch the propeller anytime the motor is running. Pay equally
close attention to items such as loose clothing, shirtsleeves, ties,
scarves, long hair or anything that may become entangled in the
spinning prop. If your fi ngers, hands, etc. come in contact with
the spinning propeller, you may be severely injured.
● The speed and mass of this boat can infl ict property damage and
severe personal injury if a collision occurs. Never run this boat
in the presence of swimmers or where the possibility of collision
with people or property exists.
● Electric motors produce heat. Do not touch any part of your motor
until it has cooled.
● This boat is controlled by radio signals, which are susceptible
to possible interference from other R/C transmitters, paging
systems, or other electrical noise.
● In the event that weeds become entangled in the propeller, stop
the motor before attempting to remove them.
● If your boat should happen to stall, water currents will slowly
carry it to shore. Keep in mind that the boat could be carried to
the opposite shore. When surveying areas to run your Wildcat
EP, keep variables in mind such as wind direction, size of the
lake, etc. It is not advisable to run R/C boats on any free-fl owing
bodies of water such as creeks or rivers.
● Always remove the battery pack from the boat before charging.
SPECIFICATIONS
WILDCAT EP BOAT SPECIFICATIONS
Length: 26.5" (673mm)
Overall: 29" (737mm)
Beam:
9" (229mm)
Height: 5.5" (140mm)
Weight: 32oz. (89grams) (RTR w/o batteries)
Run times: 4 to 6 minutes
Speeds: Up to 25mph
BOAT FEATURES
➧ Tactic ™ TTX240 2.4GHz transmitter with TR325 receiver
➧ 1800Kv brushless out-runner motor
➧ LiPo ready (3S) 50 Amp brushless motor controller with low
battery warning system and battery cut off circuit
➧ Tough, light-weight ABS construction with square hatch
opening for easy taping
➧ Great looking pre-applied graphics
➧ Twin rudders with breakaway shear bolt design
ALSO INCLUDES
➧ Surface drive propeller system
➧ Water-cooled motor mount
➧ Breakaway twin rudders
➧ Transom mounted water pickup
➧ 1/8" [3.2mm] prop shaft
➧ Two blade FRP propeller
➧ Transom drain plug
MOTOR
KV
rating: 1800kv
Operate current: 3.8A, 8V/DC (Without loading, 8V/DC)
Input: 3-S LiPo battery
Max current: 55A/15S
Shaft diameter: 4 mm
Motor resistance: 37 m 
Dimension: 35 mm
 36 mm
Weight: 107g ±10g
Plugs: 4 mm
MOTOR CONTROLLER
Amps: 50 amp continuous
Max Amps: 65A 10 sec
Voltage range: 9V-12.6V
BEC: 5V 2A
Motor Connectors: 4mm bullet (3)
Battery Connector: Deans ®
Stutter Voltage: 9.7 volts
LVC: 9 volts
Wire Gauge: #14
Max Output Power: 500 watts
On-Resistance: 0.0015 ohms
Operating Frequency: 8KHZ PWM , 16MHZ MCU
Timing
Angle: Auto
AQUB1810 Wildcat EP Mnl.indd 3 AQUB1810 Wildcat EP Mnl.indd 3 10/3/2011 2:04:48 PM 10/3/2011 2:04:48 PM