AquaCraft Rio 51Z - Manual (Page 8)

8
INSTALLING THE RUDDER BLADE
1. Remove the 3mm and 4mm nuts and
bolts from the rudder pivot bracket.
2. Insert the rudder into the rudder control arm assembly as
shown. Replace the 4 x 15mm screw and 3 x 15mm screw
and secure them with the 4mm and 3mm nuts, respectively.
CHECK THE RADIO SYSTEM
1. Stand behind the boat with both the transmitter and
receiver turned on. Rotate the steering wheel to the left.
The back of the rudder should move to the left.
2. Move the steering wheel to the right. The back of the
rudder should move to the right. If this is not the case,
simply move the steering servo reverse switch located on
the front of the transmitter (2) to the other position.