AquaCraft Revolt 30 - Manual (Page 7)

7
2. Solder the wire across the two solder tabs, creating a bridge
between the two tabs. Use your side cutters to remove the
excess wire.
3. Cut the shrink tube to around 1" long and place over the
connecter and exposed solder work. Shrink the tubing and with
the tube still warm pinch the end closed.
4. To use this system simply plug the adaptor into one of the
two battery leads coming from the controller. When you plug the
battery pack into the open connector the system will power up.
OPTION 2 (Simple to do but would
require you to make an adaptor
to again use two 2S packs):
Tools and supplies needed are:
1 length of medium shrink tubing
Soldering Iron, (TrakPower TK950 (TKPR0950)
Solder, (TrakPower Lead Free Solder (TKPR0975)
Hobby knife
Lighter or heat gun
1. Start by removing the shrink tube from end of the black wire
leading from the controller as well as the shrink tube leading
from the black harness wire.
2. Next, un-solder the two wires leads you just exposed. Slide
a length of shrink tubing over the black wire leading from the
controller and solder the lead to the open tab of the still remaining
connector. Slide the shrink tube in place and heat to shrink. Your
system is now ready to use.