AquaCraft Rescue 17 - Manual (Page 4)

4 4 4
Using CA, glue the peg on the bottom of the antenna into the
hole in the lightmast.
BATTERY PACK INSTALLATION
IMPORTANT!
Never leave a charger and battery pack unattended
while charging.
Use only the recommended batteries and appropriate
charger.
Do not attempt to charge the battery while it is in
the boat.
Refer to the instructions included with your charger
for proper battery charging procedure.
Peel the backing off of the supplied hook and loop material
and apply the “loop” side to the battery pack. Place the fully-
charged battery pack onto the battery tray as shown.
Plug the battery pack into the boat’s ESC (Electronic Speed
Control) battery connector. Do not force them together; they
are designed to fi t together only one way. WARNING: Unplug
the battery any time the boat is not in use.
Radio System
INSTALL THE TRANSMITTER BATTERIES
IMPORTANT NOTE: The transmitter is not water resistant
and should never come in contact with water!
Slide the battery door off from the back of the transmitter.
Install four fresh “AA” batteries in the confi guration molded
into the battery holder. Reinstall the battery door.