AquaCraft Motley Crew - Manual (Page 6)

6
MAINTENANCE
Here are some basic maintenance routines.
After each day of operation we feel it’s best to remove the motor
and fl ush it out with a moisture displacer and re-oil the bearings.
You are going to need the following tools and supplies.
12mm open end wrench
10mm open end wrench
2.5mm hex wrench
W ater displacer (WD-40,
CRC-56 or Corrosion X)
Bearing oil
A quaCraft Grimracer Speed
Grease (AQUB9500)
Paper Towels
Start by removing the water lines to the motor jacket.
Also unplug the three connector leads to the motor.
Use the 12mm and 10mm wrenches to loosen the cable
coupler from the cable. To do so hold the 12mm wrench
still and rotate the 10mm wrench counterclockwise.
Fully loosen the coupler. Using a rag cover the prop and
fi rmly pull the prop and shaft away from the coupler. Use
a 2.5mm hex wrench to loosen the two motor screws.
Remove the motor from the boat.