American Diagnostic Corporation (ADC) Adimals 2150 - Manual (Page 3)

WARNING: Follow local ordinances and recycling instructions regarding disposal or recycling of the
device and device components, including batteries.
WARNING: This product may contain a chemical known to the state of California to cause cancer,
birth defects, or other reproductive harm.
CAUTION: Do not use the pulse oximeter in an explosive atmosphere.
CAUTION: SpO2 and pulse rate data is displayed for informational purposes only and does not con-
stitute a diagnosis or medical advice of any kind. Only a qualified healthcare professional should in-
terpret the data obtained on this device.
CAUTION: Check the pulse oximeter sensor application site frequently to determine the positioning
of the sensor and circulation and skin sensitivity of the patient.
CAUTION: The pulse oximeter is not for continuous monitoring.
CAUTION: Prolonged use or the patient's condition may require changing the sensor site periodically.
Change sensor site and check skin integrity, circulatory status, and correct alignment at least every 4 hours.
CAUTION: Inaccurate measurements may be caused by autoclaving, ethylene oxide sterilizing, or
immersing the sensors in liquid.
CAUTION: The device should not be used on an extremity with a blood pressure cuff, arterial
catheter, or intravascular line.
CAUTION: Do not use this pulse oximeter in situations where alarms are required. This device has
no alarm.
Brief Description of Front Panel
The PR Bar graph displays corresponding with the patient’s pulse beat. The height of the bar graph
shows the patient’s pulse strength.
Included Pulse Oximeter Accessories
One (1) lanyard •
Two (2) AAA batteries •
One (1) user manual •
One (1) Safety Bumper •
One (1) Carry Case •
Battery Installation
1. Remove battery compartment top, by sliding cover in direction
of the arrow, until it pops open.
2. Insert two AAA batteries into battery compartment being sure to
observe the correct polarities. (Figure 1)
3. Replace the battery cover by reversing step 1.
Note: Be sure to observe correct battery polarity. Failure to do so might
damage the device. If device will not be used for an extended period of
time, remove batteries. Replace batteries when low battery symbol ap-
pears on display. Always replace BOTH batteries at the same time.
SpO
2
SpO
2
Pulse Rate
PR Bargraph
SpO
2
waveform
Pulse Rate
Low Power Indicator
Power
Switch
(Figure 1)