Visit ip camera from lan, An connection, Earch and set the ip address of the ip camera – Agasio A632W User Manual
Page 7: 3 visit ip camera from lan, 1 lan connection, 2 search and set the ip address of the ip camera
H Series IP Camera User Manual – Mega pixels of waterproof
7
the rear cover.
Press the Reset button for 5 seconds or more, the device will return to factory
default and reboot automatically. Please don’t cut off the power of device during this
time.
Factory default IP address is 192.168.0.158, User name: admin, password:
123456.
Note: please use 12V power adapter
3 Visit IP Camera from LAN
3.1 Lan connection
Figure 3
3.2 Search and set the ip address of the ip camera
Run “HSearch_en.exe” in the CD, the setting interface as figure 4. Operation Steps:
1)
Click “Search (F3);
2) Choose the device;
3) Change the ip address of the ip camera according to the information in the red frame
on the left. The numbers in the red circle should not be the same;
4)
Put the user name and password into “Authentication” (
By default, the user name
is: admin, password is: 123456
).
5)
Click “Update”.
6)
After successfully update, click “Search (F3)”, choose the device and click “Browse
(F4)”. Then you may view the ip camera, like figure 5.